Abbotsford
Shower Tile Installation in Abbotsford
Shower tile installation in Abbotsford, built as a waterproofed assembly rather than tile over hope. Schluter KERDI membranes, slopes that actually drain, niches and benches that land on grout lines, and glass that sits on a joint instead of cutting across a tile.
Request a Quote
Homes we work in around Abbotsford
Abbotsford and Mission give us room to work: larger homes, bigger bathrooms, acreage properties, and outdoor living spaces where exterior porcelain has become the patio surface of choice.
Showers in the 1970s to 90s homes in Clearbrook, Sandy Hill and central Abbotsford were mostly built on mortar beds or greenboard, and by now the water has usually found its way in. We open the wall, check the framing and subfloor for damage, and rebuild the shower as a complete system so the new tile is protected for decades rather than a few years.
The Eagle Mountain, Auguston and Sumas Mountain builds and the acreage homes outside the city ask for showers at architectural scale: curbless entries, linear drains, floor-to-ceiling large-format porcelain and full slab walls. The waterproofing and the slope are planned before the framing closes so the drain, the tile grid and the glass all resolve together.
Larger homes around Abbotsford often want a double shower or a full wet room off the primary bedroom. Those need more drain planning, not less, and the layout has to hold across a lot of wall. We plan them on paper before the first membrane goes up.
Scope
What we handle in Abbotsford.
- Walk-in, curbless and tub-to-shower conversions
- Schluter KERDI waterproofing, tested before tile
- Linear and centre drains with properly sloped floors
- Niches, benches and mitred edges
- Large-format porcelain, natural stone, mosaic and handmade tile
- Coordination with plumbers and glass installers
The full Shower Tile Installation page covers process, materials, and more of the questions we get asked. For everything else we do in the city, see tile contractor in Abbotsford.
FAQ
Common questions in Abbotsford.
Can you rebuild a shower that's leaking in Abbotsford?
Yes, and it's the most common shower call we get. A leaking shower almost always failed beneath the tile, so we rebuild the assembly rather than patch the surface. We'll show you what we find behind the wall before we close it up again.
How long does a shower tile installation take?
A standard walk-in shower usually runs five to eight working days from demolition to grouted tile, with the waterproofing cure and leak test built in. Curbless floors, natural stone and complex layouts run longer. The schedule is confirmed after the site visit.
Do you install the shower glass too?
We coordinate it. The glass installer measures after the tile is finished, and we plan the layout so the panel lands on a grout joint and the curb or floor is ready for it. You get one clean line where glass meets tile.
Areas we cover in Abbotsford
Clearbrook, Eagle Mountain, Auguston, Sumas Mountain, Mill Lake, West Abbotsford, Sandy Hill, Mission, Silverdale, and the rest of Abbotsford. If you're just outside those, ask anyway.
Also in Abbotsford
Other tile services in Abbotsford.
Nearby
Shower Tile Installation near Abbotsford.
Working in Abbotsford